Differences

This shows you the differences between two versions of the page.

--- formech_1372:formech_1372 [2023/05/12 01:16] – [Tested mould materials include:] formlab
+++ formech_1372:formech_1372 [2023/12/18 00:45] – [General tips] formlab
@@ Line 187: / Line 187: @@
   * **Bubble moulding**: The table should be lowered. If it's in the up-position, the air can't pass the seals.
+===== Drying sheets with the oven =====
+Use one of the ceramics oven in the metal atelier.\\
+The control cabinet is behind the oven. \\
+{{:formech_1372:oven_metal_atelier_01.jpg?400|}}\\
+Get the key from Peter to be able to power on the oven.\\
+To turn on the oven, insert the key and turn it to the right. Then turn the red knob to the right.\\
+==== Control panel ====
+{{:formech_1372:oven_metal_atelier_02_control_panel.jpg|}}
+  * There are 9 programs
+  * Each program can have multiple segments
+    * Example: segment 1: warm up to 70° in 30 min, segment 2: keep that temperature for 4 hours
+  * Each segment has 2 values: a temperature, and a time
+  - Press 'program' until it goes to program 5
+    - Nothing is on here yet. (This might change in the future)
+    - Press until there's an empty preset
+    - In the future there might be a paper with an explanation of what programs do what. I could have a fixed entry on the list
+  - Segment 1' is blinking. Use the up-down arrows to set a target temperature
+  - Press the --> arrow to go to the time value
+  - Set the time with the up-down arrows
+==== Suggested program ====
+  * Segment 1: temp: 70° time: 30 min
+  * Segment 2: temp: 70° time: 4 hours
+  * Segment 3: temp: 0° time: 30 min
 ===== Clamping tips for high gauge sheets =====
   * Apply 80 grit strips of sand paper to the underside of the clamp frame to provide more grip on the sheet. The strips can be held in place with a good quality double sided tape, contact adhesive or preferably a silicone adhesive to take the heat.