Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
hyrel:hyrel [2020/10/08 08:12] – [Tests] formlab | hyrel:hyrel [2020/10/12 06:26] – [Tests] formlab | ||
---|---|---|---|
Line 57: | Line 57: | ||
* '' | * '' | ||
* '' | * '' | ||
- | * --> **Definitive | + | * --> **Yes, this has a definitive |
* A thicker first layer height (Slic3r print profile) | * A thicker first layer height (Slic3r print profile) | ||
* Up till now all layer heights were the same. Maybe increasing the first layer could help with the adhesion. | * Up till now all layer heights were the same. Maybe increasing the first layer could help with the adhesion. | ||
Line 64: | Line 64: | ||
* --> First layer failed. All consecutive layers failed too. | * --> First layer failed. All consecutive layers failed too. | ||
* This was not a test of finding out influence. This is purely Slic3r-profile driven. | * This was not a test of finding out influence. This is purely Slic3r-profile driven. | ||
- | * <wrap hi>Do this test again</ | + | * <wrap hi>Do this test again, with a more subtle setting.</ |
* Could it be temperature? | * Could it be temperature? | ||
* Environment temperature: | * Environment temperature: | ||
+ | * --> **Yes, A room temperature of '' | ||
* Slower speed helps (no tearing), but lines are a little crumbly at '' | * Slower speed helps (no tearing), but lines are a little crumbly at '' | ||
+ | * Material Flow Rate Multiplier (in the Head-control section). Adjustments are sent to print head when pressing enter, or when clicking outside the number box (setting the cursor in another number box). This setting is thus live and overrides the Slic3r material flow parameter. | ||
Line 92: | Line 94: | ||
Future tests | Future tests | ||
* Do a visual test (video recording?) with lines on paper to see if the printer really moves 8mm/s. I have a feeling the printer moves faster than the first successful print. | * Do a visual test (video recording?) with lines on paper to see if the printer really moves 8mm/s. I have a feeling the printer moves faster than the first successful print. | ||
- | | + | |
* Try printing again with a heated bed (20° | * Try printing again with a heated bed (20° | ||
* Unrelated to this problem: I should try out more agressive prime and unprime settings. (Definite influence). | * Unrelated to this problem: I should try out more agressive prime and unprime settings. (Definite influence). | ||
- | * Live '' | + |