Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
hyrel:hyrel [2020/10/12 06:26] – [Tests] formlab | hyrel:hyrel [2020/10/12 07:51] – [Random knowledge] formlab | ||
---|---|---|---|
Line 70: | Line 70: | ||
* Slower speed helps (no tearing), but lines are a little crumbly at '' | * Slower speed helps (no tearing), but lines are a little crumbly at '' | ||
* Material Flow Rate Multiplier (in the Head-control section). Adjustments are sent to print head when pressing enter, or when clicking outside the number box (setting the cursor in another number box). This setting is thus live and overrides the Slic3r material flow parameter. | * Material Flow Rate Multiplier (in the Head-control section). Adjustments are sent to print head when pressing enter, or when clicking outside the number box (setting the cursor in another number box). This setting is thus live and overrides the Slic3r material flow parameter. | ||
+ | * Head Control - Nozzle size overrides the nozzle size set in Slic3r. | ||
Line 96: | Line 97: | ||
* 5mm/s or 8mm/s is not a problem when material is at room temperature (when the lab is not cold) | * 5mm/s or 8mm/s is not a problem when material is at room temperature (when the lab is not cold) | ||
* Try printing again with a heated bed (20° | * Try printing again with a heated bed (20° | ||
- | * Unrelated to this problem: I should try out more agressive | + | * Unrelated to this problem: I should try out more aggressive |
+ | |||
+ | |||
+ | ==== Issues ==== | ||
+ | * Printer sometimes doesn' | ||
+ | * After stopping the print (Kill function), **reset Z-zero** | ||
+ | |||
+ | |||
+ | |||
+ | ==== Random knowledge ==== | ||
+ | * '' | ||
+ | * '' | ||
+ | * '' | ||
+ | * Davo 01/10/2015 | ||
+ | * **Reset**: will reboot the 407 motion controller | ||
+ | * **Aux**: will toggle a relay, which can be used to allow or deny power to an auxiliary item like an air filter or heater | ||
+ | * **Respond**: |