Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
isel_icv4030:isel_icv4030 [2021/01/26 01:43] – formlab | isel_icv4030:isel_icv4030 [2023/05/10 05:52] – [What does it cost?] formlab | ||
---|---|---|---|
Line 9: | Line 9: | ||
* [[Milling PCB' | * [[Milling PCB' | ||
* [[isel_icv4030: | * [[isel_icv4030: | ||
+ | * [[isel_icv4030: | ||
---- | ---- | ||
- | === What does it cost? === | + | ===== What does it cost? ===== |
- | ( item cost * item count or item length (in centimeters) * material multiplier ) | + | |
+ | + | ||
- | ( machine time (hours) * machine multiplier ) | + | |
+ | |||
+ | * item count or item length: sheet items are counted per piece. Rectangular or square bars are counted per centimeter | ||
+ | * material multiplier: item cost * item count * 2 (included in the table below) | ||
+ | * machine time multiplier: | ||
+ | * For projects under 2 hours: €7 per hour | ||
+ | * For projects over 2 hours and under 5 hours: €6,5 per hour | ||
+ | * For projects over 5 hours: €6 per hour | ||
+ | |||
+ | ---- | ||
+ | |||
+ | {{: | ||
+ | ===== Available material ===== | ||
+ | |||
+ | ^ Material ^ Dimensions ^ Cost ^ | ||
+ | | Aluminum plate | 280x140x8mm | €6,90 per piece | | ||
+ | | Aluminum plate | 300x260x5mm | €7,95 per piece | | ||
+ | | square bar | 20x20mm | €0,15 per cm | | ||
+ | | square bar | 40x40mm | €0,30 per cm | | ||
+ | | square bar | 60x60mm | €0,60 per cm | | ||
+ | | rectangular bar | 80x30mm | €0,60 per cm | | ||
+ | | rectangular bar | 80x40mm | €0,75 per cm | | ||
+ | | rectangular bar | 150x15mm | €0,60 per cm | | ||
+ | | rectangular bar | 200x10mm | €0,45 per cm | | ||
+ | | rectangular bar | 200x20mm | €0,90 per cm | | ||
+ | |||
+ | ---- | ||
+ | |||
+ | === Aluminum === | ||
+ | Tested alloy: 6082 / ALMgSi1 | ||
+ | [[https:// | ||
+ | |||
+ | === Messing === | ||
+ | Tested alloy: CuZn 37 | ||
+ | |||
+ | ===== Milling tips ===== | ||
+ | * Foam | ||
+ | * single flute | ||
+ | * down cut | ||
+ | * 3000mm/min and 18-24, | ||
+ | * use conventional milling | ||