other:kicad_overview

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
other:kicad_overview [2020/04/30 04:38] – [Part 2: Create a Schematic Symbol] formlabother:kicad_overview [2020/04/30 04:41] – [Part 2: Create a Schematic Symbol] formlab
Line 78: Line 78:
     * Min track width: ''10 mil''     * Min track width: ''10 mil''
     * Min via diameter: ''32 mil'' (total width of the drill hole including both sides of the annular ring)     * Min via diameter: ''32 mil'' (total width of the drill hole including both sides of the annular ring)
-    * Min via drill diameter: ''15 mil''+    * Min via: ''15 mil'' (The drill diameter)
   * ''File > Board Setup > Design Rules > Net Classes''. In the default net-class, change the following values:   * ''File > Board Setup > Design Rules > Net Classes''. In the default net-class, change the following values:
     * Clearance: ''10 mils''     * Clearance: ''10 mils''
  • other/kicad_overview.txt
  • Last modified: 2020/09/11 04:55
  • by formlab