Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| 3d_modeling:blender:clean_up_occipital_3d_scan [2021/10/13 03:05] – [Join fragments to a single mesh] formlab | 3d_modeling:blender:clean_up_occipital_3d_scan [2021/10/13 03:07] (current) – [Auto-fix holes] formlab | ||
|---|---|---|---|
| Line 36: | Line 36: | ||
| * Try selecting the non-manifold vertexes again. If there are still some selected, repeat the above process, or export the object to Meshmixer to remesh it there. | * Try selecting the non-manifold vertexes again. If there are still some selected, repeat the above process, or export the object to Meshmixer to remesh it there. | ||
| + | The 3D print add-on for Blender is helpful in preparing your object for 3D printing: enable the add-on '' | ||
| ==== Delete unwanted geometry ==== | ==== Delete unwanted geometry ==== | ||
| Cut away unwanted parts, like the surface the model was standing on. | Cut away unwanted parts, like the surface the model was standing on. | ||