Differences

This shows you the differences between two versions of the page.

--- 3d_modeling:meshmixer [2020/01/27 03:47] – formlab
+++ 3d_modeling:meshmixer [2020/03/25 07:25] (current) – formlab
@@ Line 2: / Line 2: @@
+[[3d_modeling:Meshmixer:Clean up 3D scan]]
+----
+[[Split 3D model|{{:3d_modeling:split_poster.jpg?400|}}]]\\
+[[Split 3D model]]
+----
 [[Join two meshes by closing the gap between them|{{:3d_modeling:meshmixer-join-poster.jpg?nolink400|}}]]\\
@@ Line 11: / Line 20: @@
 [[Join two meshes by snapping one of them to the surface of the other|{{:3d_modeling:meshmixer-join-by-library-poster.jpg?400|}}]]\\
 [[Join two meshes by snapping one of them to the surface of the other]].
+----
+===== Quick tips =====
@@ Line 24: / Line 37: @@
 {{:3d_modeling:meshmixer-snap-increments.jpg?nolink400|}}\\
 Adjust the snap increments with the arrow keys
+{{:3d_modeling:meshmixer-select_edge_of_hole.jpg|}}