formech_1372:formech_1372

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
formech_1372:formech_1372 [2025/01/13 02:12] – [How much does it cost?] formlabformech_1372:formech_1372 [2025/12/04 02:44] (current) – [Materials allowed in Formlab] formlab
Line 12: Line 12:
   * Large: ''1370 x 660mm''   * Large: ''1370 x 660mm''
  
 +
 +[[https://www.formlab.schoolofarts.be/pricing|What does it cost?]]
 === Pre-drying === === Pre-drying ===
   * PMMA: 70°C 4 hours   * PMMA: 70°C 4 hours
Line 127: Line 129:
   * **Forming temp range**: ''120–160°C''   * **Forming temp range**: ''120–160°C''
   * **Conclusion**: Easy to form and stronger than HIPS, ±50% more expensive   * **Conclusion**: Easy to form and stronger than HIPS, ±50% more expensive
 +
 +  * **Lasercutting**: Speed 40, Power 40, trace 2 times
  
  
Line 200: Line 204:
   - Press 'program' until it goes to program 5   - Press 'program' until it goes to program 5
     - Nothing is on here yet. (This might change in the future)     - Nothing is on here yet. (This might change in the future)
-    - Press until there's an empty preset+    - Press the --> arrow until there's an empty preset
     - In the future there might be a paper with an explanation of what programs do what. I could have a fixed entry on the list     - In the future there might be a paper with an explanation of what programs do what. I could have a fixed entry on the list
   - Segment 1' is blinking. Use the up-down arrows to set a target temperature   - Segment 1' is blinking. Use the up-down arrows to set a target temperature
  • formech_1372/formech_1372.1736763168.txt.gz
  • Last modified: 2025/01/13 02:12
  • by formlab