Differences

This shows you the differences between two versions of the page.

--- hyrel:general_slicer_info [2020/10/06 04:20] – created formlab
+++ hyrel:general_slicer_info [2020/10/06 04:26] (current) – formlab
@@ Line 3: / Line 3: @@
   - Slic3r profile files are stored in ''C > Users > Elias Heuninck > AppData > Roaming > Slic3r > print''
     - This way they can be found & loaded by the Repetrel sofware.
-  - Hyrel standard recipe naming convention: ''0.5w, 0.2z, 30f, 35pct.ini'' = ''nozzle width, layer thickness, travel speed, infill percentage''.
+  - Hyrel standard recipe naming convention: \\ ''0.5w, 0.2z, 30f, 35pct.ini'' = \\ ''nozzle width, layer thickness, travel speed, infill percentage''.
-|0.5w|0.2z|30f|35pct|
+  - Generally it's sufficient to customise only the print settings profile, as the printer- and extruder profiles are already set up for all possible configurations.
-|---|---|---|---|
-|nozzle width|layer thickness|travel speed|infill percentage|
-  - Generally it's sufficient to customise only the print settings profile.
-=== Default profiles ===
-  - Plasticine
-    - Print: ''xxx'' <wrap hi>(define after testing)</wrap>
-    - Printer: ''Unheated Head''
-    - Extruder 2: ''No heat, no fan, no bed''
 === Print settings ===
@@ Line 38: / Line 26: @@
   - **Speed**
     - Use same speed for all moves (print and non-print moves)
-    - 8mm/s is a nice and conservative speed. <wrap hi>Fact check please</wrap>
+    - ''8mm/s'' is a nice and conservative speed.
   - Multiple extruders
     - set to 1