This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |
| hyrel:tips [2020/10/06 05:33] – formlab | hyrel:tips [2020/10/06 05:47] (current) – formlab |
|---|
| * <wrap hi>Choosing another Slicer Profile</wrap> | * <wrap hi>Choosing another Slicer Profile</wrap> |
| * Make sure you <wrap hi>select first the project file (Main) and then the 3D object</wrap> in the project window <wrap hi>before choosing a new slicing profile</wrap>. This is a quirk of the Repetrel software. Make sure to Add consistent notes to the slicer profiles, so you can notice them in the G-code preview (they are printed on top of the file). This makes it easier to see exactly which profile you selected | * Make sure you <wrap hi>select first the project file (Main) and then the 3D object</wrap> in the project window <wrap hi>before choosing a new slicing profile</wrap>. This is a quirk of the Repetrel software. Make sure to Add consistent notes to the slicer profiles, so you can notice them in the G-code preview (they are printed on top of the file). This makes it easier to see exactly which profile you selected |
| * Dialing in new material settings: https://madprinter.org/2016/07/05/dialing-in-material-settings/ | |
| | ====== Dialing in new material settings ====== |
| | * Apart from the slicer profile, the tool-head controls the flow of material |
| | * ''Prime'': whenever transitioning from a non-printing move to a printing move. |
| | * ''Unprime'': whenever transitioning from a printing move to a non-printing move. |
| | * Adjust these settings by halving or doubling the steps and rate, making a test print and then reassessing. |
| | * More info: https://madprinter.org/2016/07/05/dialing-in-material-settings/ |
| |
| |
| |