isel_icv4030:engraving_large_pockets

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision		Previous revision
isel_icv4030:engraving_large_pockets [2020/02/19 06:34] – created formlabisel_icv4030:engraving_large_pockets [2020/02/19 06:54] (current) – formlab
Line 1: Line 1:
 ====== Engraving large pockets ====== ====== Engraving large pockets ======
-{{:isel_icv4030:engraving-large-pockets-poster.jpg|}}+{{:isel_icv4030:engraving-large-pockets-poster.jpg?400|}}\\ 
 To engrave pockets that are wider than the chamfer tool's diameter, follow these steps: To engrave pockets that are wider than the chamfer tool's diameter, follow these steps:
  
   * In this example, the engraving should be 3mm deep   * In this example, the engraving should be 3mm deep
   * **OP 1**: 2D pocket.    * **OP 1**: 2D pocket. 
-    * Set bottom height to be selected contour with an offset of -3mm.+    * Set bottom height to the selected contour with an offset of -3mm.
     * under radial stock to leave, enter the radius of the V-bit at 3mm from the tip     * under radial stock to leave, enter the radius of the V-bit at 3mm from the tip
-      * calculate as follows: +      * to calculate this offset, make a cross-sectional drawing of the V-bit and measure the diameter at the correct distance (3mm) from the tip. Divide this length to become the radius. 
-      * {{:isel_icv4030:engraving_large_pockets-calculate_radial_offset.png|}}+      * {{:isel_icv4030:engraving_large_pockets-calculate_radial_offset.png?400|}}\\ 
   * **OP 2**: Engraving operation with V-bit   * **OP 2**: Engraving operation with V-bit
-    * Set bottom height to be selected contour with an offset of -3mm.+    * Set bottom height to the selected contour with an offset of -3mm.
  
  
  • isel_icv4030/engraving_large_pockets.1582122882.txt.gz
  • Last modified: 2020/02/19 06:34
  • by formlab