isel_icv4030:engraving_large_pockets

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
isel_icv4030:engraving_large_pockets [2020/02/19 06:53] – formlabisel_icv4030:engraving_large_pockets [2020/02/19 06:54] (current) – formlab
Line 7: Line 7:
     * Set bottom height to the selected contour with an offset of -3mm.     * Set bottom height to the selected contour with an offset of -3mm.
     * under radial stock to leave, enter the radius of the V-bit at 3mm from the tip     * under radial stock to leave, enter the radius of the V-bit at 3mm from the tip
-      * to calculate the offset, make a cross-sectional drawing of the V-bit and measure the diameter at the correct distance (3mm) from the tip. Divide this length to become the radius.+      * to calculate this offset, make a cross-sectional drawing of the V-bit and measure the diameter at the correct distance (3mm) from the tip. Divide this length to become the radius.
       * {{:isel_icv4030:engraving_large_pockets-calculate_radial_offset.png?400|}}\\        * {{:isel_icv4030:engraving_large_pockets-calculate_radial_offset.png?400|}}\\ 
   * **OP 2**: Engraving operation with V-bit   * **OP 2**: Engraving operation with V-bit
  • isel_icv4030/engraving_large_pockets.1582124002.txt.gz
  • Last modified: 2020/02/19 06:53
  • by formlab