Differences

This shows you the differences between two versions of the page.

--- isel_icv4030:isel_icv4030 [2021/01/26 01:44] – formlab
+++ isel_icv4030:isel_icv4030 [2025/01/13 02:04] (current) – [Available material] formlab
@@ Line 8: / Line 8: @@
   * [[Milling PCB's]]
+  * [[Milling PCB's v2]]
   * [[isel_icv4030:Engraving large pockets]]
+  * [[isel_icv4030:Engraving detailed images]]
 ----
-=== What does it cost? ===
+[[https://www.formlab.schoolofarts.be/pricing|What does it cost?]]
-  ( item cost * item count or item length (in centimeters) * material multiplier )
+{{:isel_icv4030:materials-aluminum.jpg|}}
-  +
+===== Available material =====
-  ( machine time (hours) * machine multiplier )
- * item count or item length: sheet items are counted per piece. Rectangular or square bars are counted per centimeter
+^ Material ^ Dimensions ^
-  * material multiplier: 50%: item cost * item count * 1,5
+| Aluminum plate | 280x140x8mm |
-  * machine multiplier: €5 per hour
+| Aluminum plate | 300x260x5mm |
+| square bar | 20x20mm |
+| square bar | 40x40mm |
+| square bar | 60x60mm |
+| rectangular bar | 80x30mm |
+| rectangular bar | 80x40mm |
+| rectangular bar | 150x15mm |
+| rectangular bar | 200x10mm |
+| rectangular bar | 200x20mm |
 ----
-{{:isel_icv4030:materials-aluminum.jpg|}}
+=== Aluminum ===
-==== Available material ====
+Tested alloy: 6082 / ALMgSi1
+[[https://testas.be/|Testas]]: [[https://mcbgroup.eu/app/uploads/sites/2/2018/01/DS31-6082-gewalst.pdf|data sheet]]
-^ Material ^ Dimensions ^ Cost ^
+=== Messing ===
-| Aluminum plate | 280x140x8mm | €6,90 per piece |
+Tested alloy: CuZn 37
-| Aluminum plate | 300x260x5mm | €7,95 per piece |
-| square bar | 20x20mm | €0,15 per cm |
-| square bar | 40x40mm | €0,30 per cm |
-| square bar | 60x60mm | €0,60 per cm |
-| rectangular bar | 80x30mm | €0,60 per cm |
-| rectangular bar | 80x40mm | €0,75 per cm |
-| rectangular bar | 150x15mm | €0,60 per cm |
-| rectangular bar | 200x10mm | €0,45 per cm |
-| rectangular bar | 200x20mm | €0,90 per cm |
-----
+===== Milling tips =====
+  * Foam
+    * single flute
+    * down cut
+    * 3000mm/min and 18-24,000rpm depending on bit diameter
+    * use conventional milling
-[[https://testas.be/|Testas]]: Aluminum: 6082 / ALMgSi1 - [[https://mcbgroup.eu/app/uploads/sites/2/2018/01/DS31-6082-gewalst.pdf|data sheet]]