Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| ultimaker_original:calibrate_e-steps [2020/01/06 05:20] – [2: Tuning extrusion multiplier] formlab | ultimaker_original:calibrate_e-steps [2020/01/06 05:21] (current) – [1: calibrate E-steps per mm] formlab | ||
|---|---|---|---|
| Line 19: | Line 19: | ||
| * G1 E100 | * G1 E100 | ||
| * cool down hot end | * cool down hot end | ||
| - | * measure from the underside of the feeder to the mark made previously. If it measures 20mm you're good and you can skip the next steps. If not, keep reading. | + | * measure from the underside of the feeder to the mark made previously. |
| + | |||
| + | If it measures 20mm you're good and you can skip the next steps. If not, keep reading. | ||
| * Get the existing E-steps/mm value | * Get the existing E-steps/mm value | ||
| * send M503 | * send M503 | ||