Show pageOld revisionsBacklinksBack to top This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong. ====== Clean up 3D scan ====== ===== Clean up glitches ===== {{:3d_modeling:blender:clean-up-glitch-01.jpg|}}\\ Sometimes a 3D scan has jagged protrusions. {{:3d_modeling:blender:clean-up-glitch-02.jpg|}}\\ * Go to the sculpting workspace * select the 'Simplify' brush * Set autosmooth to 1 * enable 'Dyntopo' * Change the 'Refine Method' to 'Collapse Edges' * Deselect button 'X' in the Symmetry tab {{:3d_modeling:blender:clean-up-glitch-03.jpg|}}\\ Sculpt over the glitch-feature. It should easily disappear. ---- 3d_modeling/blender/clean_up_3d_scan.txt Last modified: 2020/02/18 04:02by formlab