Show pageOld revisionsBacklinksBack to top This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong. ==== Loose belts ==== * Check if bolts on the underside of the Y-beams in the back are nice and tight. Don't screw them in too tights as they might make a hole through the belt. * Loosen both bolts in the front * With one hand, pull the belt tight. With the other, fasten the bolt. * Repeat for the other bolt in the front. {{:openbuilds_acro:acro_1510_small_01_loose_belts.jpg?400|}} openbuilds_acro/loose_belts.txt Last modified: 2024/08/26 05:11by formlab