Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
isel_icv4030:isel_icv4030 [2020/02/19 05:27] – formlab | isel_icv4030:isel_icv4030 [2021/09/22 00:18] – [Isel ICV 4030 - CNC milling machine] formlab | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Isel ICV 4030 - CNC milling machine ====== | ====== Isel ICV 4030 - CNC milling machine ====== | ||
{{: | {{: | ||
+ | |||
+ | |||
+ | * Max Model Dimensions (X - Y): '' | ||
+ | |||
+ | ---- | ||
* [[Milling PCB' | * [[Milling PCB' | ||
* [[isel_icv4030: | * [[isel_icv4030: | ||
+ | * [[isel_icv4030: | ||
+ | |||
+ | ---- | ||
+ | |||
+ | ===== What does it cost? ===== | ||
+ | |||
+ | ( item cost * item count or item length (in centimeters) * material multiplier ) | ||
+ | + | ||
+ | ( machine time (hours) * machine multiplier ) | ||
+ | |||
+ | * item count or item length: sheet items are counted per piece. Rectangular or square bars are counted per centimeter | ||
+ | * material multiplier: 50%: item cost * item count * 1,5 (included in the table below) | ||
+ | * machine multiplier: €5 per hour | ||
+ | |||
+ | ---- | ||
+ | |||
+ | {{: | ||
+ | ===== Available material ===== | ||
+ | |||
+ | ^ Material ^ Dimensions ^ Cost ^ | ||
+ | | Aluminum plate | 280x140x8mm | €6,90 per piece | | ||
+ | | Aluminum plate | 300x260x5mm | €7,95 per piece | | ||
+ | | square bar | 20x20mm | €0,15 per cm | | ||
+ | | square bar | 40x40mm | €0,30 per cm | | ||
+ | | square bar | 60x60mm | €0,60 per cm | | ||
+ | | rectangular bar | 80x30mm | €0,60 per cm | | ||
+ | | rectangular bar | 80x40mm | €0,75 per cm | | ||
+ | | rectangular bar | 150x15mm | €0,60 per cm | | ||
+ | | rectangular bar | 200x10mm | €0,45 per cm | | ||
+ | | rectangular bar | 200x20mm | €0,90 per cm | | ||
+ | |||
+ | ---- | ||
+ | |||
+ | [[https:// | ||
+ | |||
+ | ===== Milling tips ===== | ||
+ | * Foam | ||
+ | * single flute | ||
+ | * down cut | ||
+ | * 3000mm/min and 18-24, | ||
+ | * use conventional milling | ||
+ |