Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
ultimaker_3_extended:ultimaker_3_extended [2019/09/23 02:01] – [Monthly] formlab | ultimaker_3_extended:ultimaker_3_extended [2019/09/23 06:50] – [Every 2 months] formlab | ||
---|---|---|---|
Line 3: | Line 3: | ||
===== Maintenance ===== | ===== Maintenance ===== | ||
- | ==== Monthly | + | ==== Every 2 months |
* [[https:// | * [[https:// | ||
+ | * wash build plate with warm water | ||
+ | * heat up nozzles to 150°C and remove plastic stuck on the nozzle (with tweezers or a paper towel) | ||
+ | * clean Bowden tube by pushing a piece of sponge trough. Tight fit, and a new piece of sponge per tube. | ||
* [[https:// | * [[https:// | ||
+ | * one drop of Unilube on all smooth axles (also the two vertical ones). Move the print head and bed manually to distribute. | ||
- | ==== Every 3 months ==== | + | ==== Every 6 months ==== |
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
==== Yearly ==== | ==== Yearly ==== | ||
+ | * [[https:// | ||
+ | * [[https:// |