Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
ur10_robot_arm:ur10_robot_arm [2023/02/28 02:38] – [Installation] formlab | ur10_robot_arm:ur10_robot_arm [2023/04/17 01:36] – [Software] formlab | ||
---|---|---|---|
Line 8: | Line 8: | ||
* [[https:// | * [[https:// | ||
===== Software ===== | ===== Software ===== | ||
- | + | * Polyscope (the teaching pendant) | |
- | ==== Teaching pendant (Polyscope) ==== | + | * Grasshopper + Robots |
+ | * Rodo-DK | ||
+ | * Other possible control software | ||
+ | * Python | ||
+ | * [[https:// | ||
+ | ==== Polyscope | ||
=== Define TCP === | === Define TCP === | ||
Line 46: | Line 51: | ||
If Rhino keeps asking to locate the Robots.dll file, here's a tip. Make all grasshopper projects (files with a '' | If Rhino keeps asking to locate the Robots.dll file, here's a tip. Make all grasshopper projects (files with a '' | ||
* On mac: cmd + i, under sharing & permissions, | * On mac: cmd + i, under sharing & permissions, | ||
- | * Location of the robots.dll file: '' | + | * Location of the robots.dll file: |
+ | * '' | ||
== Guides == | == Guides == | ||
Line 55: | Line 61: | ||
* Robots guide by [[https:// | * Robots guide by [[https:// | ||
* Drawing with robots [[https:// | * Drawing with robots [[https:// | ||
+ | * [[https:// | ||
I tried adapting the ' | I tried adapting the ' | ||
+ | |||
+ | == Tips == | ||
+ | * The first target should be a joint target. Following ones can be cartesian targets. | ||
== Upload script to robot == | == Upload script to robot == | ||
* Small programs can be streamed directly to the robot with the ' | * Small programs can be streamed directly to the robot with the ' | ||
Line 82: | Line 92: | ||
== Setup == | == Setup == | ||
- | * Do not connect to the LAN network of KASK. Instead connect to the robot arm via a separate switch. | + | * Do not connect to the LAN network of KASK. Instead connect to the robot arm directly, or via a separate switch. |
* Set the computer to a static IP address that is the same as the Robot' | * Set the computer to a static IP address that is the same as the Robot' | ||
- | {{: | ||
+ | |||
+ | * < | ||
+ | * or | ||
+ | * < | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | == Related ' | ||
+ | * Wirecutting with Grasshopper & Robots ([[https:// | ||
==== FTP connection ==== | ==== FTP connection ==== | ||
* Use FIleZilla | * Use FIleZilla |