Differences

This shows you the differences between two versions of the page.

--- lmi_3d_scanner:configuring_scan_volume [2019/10/14 07:25] – [6. Calibrating] formlab
+++ lmi_3d_scanner:configuring_scan_volume [2021/01/14 02:58] (current) – [6. Calibrating] formlab
@@ Line 81: / Line 81: @@
 {{:lmi_3d_scanner:projector_focus_wiki.jpg?nolink|}}\\
 {{:lmi_3d_scanner:projector_focus_result.jpg?nolink|}}\\
-Set the projector focus.
+Set the projector focus. (Look at the actual calibration card, not the images from the cameras)
 ===== 4. Focus cameras =====
@@ Line 104: / Line 104: @@
 {{:lmi_3d_scanner:calibration_board_square_size_and_filter_settings_wiki.jpg?nolink|}}\\
 Match the size of the squares of the calibration card.\\
-Make sure sensible Filter values are set.
+Make sure sensible Filter values are set. (no documentation found on where the values are measured from. Possibly the CCD location of the camera's).
@@ Line 125: / Line 125: @@
-You will need 40 or more images for a qualitative calibration.
+You will need 40 or more images for a good quality calibration.
 {{:lmi_3d_scanner:calibrate-button.jpg?nolink|}}\\