lmi_3d_scanner:configuring_scan_volume

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
lmi_3d_scanner:configuring_scan_volume [2021/01/14 02:52] – [3. Focus projector] formlablmi_3d_scanner:configuring_scan_volume [2021/01/14 02:58] (current) – [6. Calibrating] formlab
Line 104: Line 104:
 {{:lmi_3d_scanner:calibration_board_square_size_and_filter_settings_wiki.jpg?nolink|}}\\ {{:lmi_3d_scanner:calibration_board_square_size_and_filter_settings_wiki.jpg?nolink|}}\\
 Match the size of the squares of the calibration card.\\ Match the size of the squares of the calibration card.\\
-Make sure sensible Filter values are set.+Make sure sensible Filter values are set. (no documentation found on where the values are measured from. Possibly the CCD location of the camera's).
  
  
  • lmi_3d_scanner/configuring_scan_volume.1610621578.txt.gz
  • Last modified: 2021/01/14 02:52
  • by formlab