prepare_for_3d_printing:prepare_for_3d_printing

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
prepare_for_3d_printing:prepare_for_3d_printing [2024/05/13 00:41] – [Per model settings] formlabprepare_for_3d_printing:prepare_for_3d_printing [2024/07/23 04:04] (current) – [Cura is slow] formlab
Line 13: Line 13:
 ==== Cura ==== ==== Cura ====
  
-  * If Cura is slow: set the option "Infill > Skin Edge Support layers" to 0+=== Cura is slow === 
 +If Cura is slow: set the option "Infill > Skin Edge Support layers" to 0 
 +{{:prepare_for_3d_printing:slow_cura_trick.png?600|}}
  
 === Per model settings === === Per model settings ===
Line 40: Line 42:
     * If the dimensions are different than the CAD model, adjust the horizontal offset.      * If the dimensions are different than the CAD model, adjust the horizontal offset. 
     * If the dimensions are the same as the CAD model, but it doesn't fit properly, adjust the clearance values in the CAD model.     * If the dimensions are the same as the CAD model, but it doesn't fit properly, adjust the clearance values in the CAD model.
-  *  
  • prepare_for_3d_printing/prepare_for_3d_printing.1715586083.txt.gz
  • Last modified: 2024/05/13 00:41
  • by formlab