Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
tripodmaker:maintenance [2020/01/15 02:46] – [Moving parts] formlab | tripodmaker:maintenance [2020/01/15 03:37] – [Cleaning] formlab | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Tripodmaker maintenance====== | ====== Tripodmaker maintenance====== | ||
+ | |||
+ | |||
+ | ==== Cleaning ==== | ||
+ | * clean v-grooved wheels | ||
+ | * clean v-rails the wheels ride on | ||
+ | * clean feeder teeth | ||
+ | * connect via usb to computer | ||
+ | * in Printrun, open port / | ||
+ | * vacuum away the dust | ||
+ | * clean hot-end | ||
+ | * check if Bowden tube doesn' | ||
+ | * clean build plate with hot water | ||
Line 5: | Line 17: | ||
Keep the wheels and magnetic bearings free of dust. These black components are made from POM and attract dust. Preventing dust to accumulate elongates their lifetime. | Keep the wheels and magnetic bearings free of dust. These black components are made from POM and attract dust. Preventing dust to accumulate elongates their lifetime. | ||
- | {{: | + | {{: |
Tightening eccentric nut. No need to loosen the hex bolt first. | Tightening eccentric nut. No need to loosen the hex bolt first. | ||