Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| tripodmaker:maintenance [2020/01/15 02:48] – formlab | tripodmaker:maintenance [2020/01/15 03:59] – [Cleaning] formlab | ||
|---|---|---|---|
| Line 3: | Line 3: | ||
| ==== Cleaning ==== | ==== Cleaning ==== | ||
| - | * clean build plate with hot water | + | {{: |
| - | * clean v-grooved wheels | + | * clean v-grooved wheels |
| * clean v-rails the wheels ride on | * clean v-rails the wheels ride on | ||
| - | * clean hot-end | ||
| * clean feeder teeth | * clean feeder teeth | ||
| + | * connect via usb to computer | ||
| + | * in Printrun, open port / | ||
| + | * vacuum away the dust | ||
| + | {{: | ||
| + | * vacuum the rod ends too. They collect tiny metal particles that are attracted to the magnet. | ||
| + | * clean hot-end | ||
| * check if Bowden tube doesn' | * check if Bowden tube doesn' | ||
| + | * clean build plate with hot water | ||