3d_modeling:blender:clean_up_3d_scan
This is an old revision of the document!
Table of Contents
Clean up 3D scan
Clean up glitches
Sometimes a 3D scan is left with jagged protrusions.
- Go to the sculpting workspace
- select the 'Simplify' brush
- Set autosmooth to 1
- enable 'Dyntopo'
- Change the 'Refine Method' to 'Collapse Edges'
- Deselect button 'X' in the Symmetry tab
Sculpt over the glitch-feature. It should easily disappear.
3d_modeling/blender/clean_up_3d_scan.1582027234.txt.gz · Last modified: by formlab