• Max Build Volume: 215 x 215 x 300mm
• Filament options

How much does FDM printing cost?

• Clean printer
  • wash build plate with warm water
  • heat up nozzles to 150°C and remove plastic stuck on the nozzle (with tweezers or a paper towel)
  • clean Bowden tube by pushing a piece of sponge trough. Tight fit, and a new piece of sponge per tube.
• Lubricate axles
  • clean all smooth axles with a paper towel
  • one drop of Unilube on all smooth axles (also the two vertical ones). Move the print head and bed manually to distribute.

• Check for play on axles
  • calibrate axles if play detected
• Check tension of short belts
• Check for residue in front fan of print head
• Check quality of silicone nozzle cover
• Clean print cores
• Lubricate lead screw Z motor

• Clean feeders
• Replace Bowden tubes

✔ Solved
27/04/2026

When you want to print via cloud you get the message 'printer not in remote clusters'.

In the browser, go to Digital factory and remove the printers that you can't print on via the cloud.

Restart the computer.
Make sure that cura is not open. Then go to the printer.

On the printer

• system > Maintenance > Digital Factory reset. (The printer restarts)
• after the restart, go to system > netword > Digital Facotory > Connect to Digital Factory. You'll get a 6 digit code

(you don't need a firmware upgrade. they are now on 5.3 which is the highest firmware. (Unmaintained, no new firmware updates coming)).

On the computer, go to Digital factory again and add a new printer. Select the 'S' printer type and add the code to pair up the printer. The printer shows it's offline, but after a minute or two it changes to the active online status.